Heavy Black Enamel Fire Pot and Hot Rod Ignitor Kit Replacement Parts for Traeger and Pit boss and Camp Chef Pellet Grill (Enamel Fire Pot and Hot Rod)

Well made product the burner pot is just as stated & no more rust.I absolutely love it vs the old one.The probe and burner pot is a easy plug and play 15-25 minutes of work to swap out.To make it easy on yourself.Remove the 8 screws on the bottom of the hopper to access the wiring you may need to cut a zip tie or 2 to get the wires free.Make sure to remove the rubber grommet where it goes in the air channel above the blower fan.Remove grill gates and take the 4 screws holding shield and burner pot in place remove the burner pot by twisting from back to front and it should come off the auger tube then loosen the screw holding the hot probe in place pull it out of the burner pot then remove the burner pot.DO NOT PULL the wire or probe out at this time.Now wrap some tape around the old hot probe end & new probes wire plug end then simply pull it through slowly till the old probe is out and the plug comes to the grommet location.I had to wiggle it a litte to get it through then removed tape slid the grommet over wire and back into place then plug the new wire back in and if needed use new zip ties to organize the wires away from the fan put the 8 screws in and your done with that part.now go back to the burner pot place the probe inside the new pot and tighten the set screw to hold it in place.now work the burner pot back over the auger tube it will be a tight fit but it will go work from back or front twist it into place.